close
close

How To Change A Brake Light On A 2018 Hyundai Elantra

How To Change A Brake Light On A 2018 Hyundai Elantra. Jan 30, 2009 • 2004 hyundai elantra. Remove the cover and access the back of the tail light assembly.

Hyundai Elantra Brake Light Bulb Replacement Guide from www.youcanic.com

This video shows you how to change the brake lights on your 2010 hyundai elantra. Remove rear tail light assembly open the rear service cover. How to change the brake light on a hyundai elantra.

If The Handle Isn’t All Of The Way Down, It’ll Cause The Brake Warning Light To Stay On.

Noticed that your taillight isn't working? Driving without the brake lights working is just as unsafe as if your elantra’s brake lights were stuck on. Remove three 10 mm nuts that hold the tail light in place.

If The Brake Pedal Is Closer To The Floor Than It Should Be, The Plunger In The Brake Pedal Switch Will No Longer Be Able To Be Pressed In All The Way.

Now you should be able to pull the rear tail light assembly from the body of your elantra. Pull out the tail light assembly. Slide the jack back under the front of the car's suspension and jack it up so that it lifts off the jack stands an inch or two.

Remove The Cover And Access The Back Of The Tail Light Assembly.

Noticed that your brake light bulb is not working? The fuse was removed in order to shut off the brake lights. The contact owns a 2013 hyundai elantra.

Prices May Vary Depending On Your Location.

Remove three 10 mm nuts that hold the tail light in place. Remove the cover and access the back of the tail light assembly. Insert a new bulb and reassemble the vehicle by following the steps in the reverse order.

Open Your Trunk And Remove The Carpet From Behind The Brake Lights, You Should Be Able To Access The Brake Light From There.

This video shows you how to change the brake lights on your 2018 hyundai elantra. How to replace brake light bulb on hyundai elantra 2011 2012 2013 2014 2015 2016 our website: Pull the bulb from the socket.

Leave a Comment